top of page

'32 Ford Roadster Center Console

A smaller, simpler project: Giving an old '32 Ford some modern interior features, without any permanent modifications to the car.

The primary criteria:

  1. Add location for radio, cupholders, phone, phone charger, and side storage for maps.

  2. Make all components 3D printable, with no exposed fasteners.

  3. Sit on car's trans tunnel with industrial velcro (no fasteners through floor pan).

  4. Had to take up as little floor space as possible - the console actually has a negative draft angle to help accomplish this, which can be seen in some of the renderings.

  5. Cup holder had to fit two cans of beer. This was the most important critera, of course.

CAD Gallery

Fabrication Gallery

bottom of page